Sharp KC-JG20A, Руководство по эксплуатации

Страница: 28 / 64

ENGLISH
E-7,16
–
–
–
–
E-10,11
E-16
～
20
E-16
E-16,17,
20,27
–
–
3
1
2
E-16
E-7,16,
27
E-26 E-27
TROUBLESHOOTING
(Continued)
Tray Partition
Insert the Tray Partition as shown in the figure below.
Click
Tray Partition
Hold it up slightly Pull it out
Symptom Remedy
Refer
to
Symptom Remedy
Refer
to
Indicator Light
• Clean the parts with in the table below. The Filter Maintenance
Indicator Light is ON.
Parts to be cleaned
Main
Unit
Water
Tank
Humidifying
Tray
Humidifying
Filter
HEPA
Filter
Back
Panel
Active Carbon & Silica Gel
Deodorizing Filter
• Press the OFF timer button for 3 seconds or more after maintenance.
(The Filter Maintenance Indicator Light turns off.)
The Filter Maintenance
Indicator Light does not
turn OFF.
• The Float might be stuck.
Clean up the Humidifying Tray, remove dirt around the Float and
mount it firmly.
• Is the Water Tank or Humidifying Tray firmly inserted to the main unit?
Be sure to mount them firmly to the main unit.
• The Float could malfunction and fail to indicate water supply properly if
it is put closer to speakers, electromagnetic cookers or other magnetic
objects.
• In the Plasmacluster Ion Shower mode or at the fan speed set to
“AUTO” or “POLLEN” in the Clean Air & Humidify mode, the unit stops
humidifying and the Humidifying Indicator Light turns OFF when it
reaches the optimal humidity.
The Humidifying
Indicator Light does not
turn ON or blinks in red
when water is contained
in the Water Tank.
• This is because humidity varies by location even in a single room.
• The accuracy or speed of response to changes in humidity varies
between the Current Humidity Indicator and other hygrometers.
(Check the humidity display as an estimated indication)
The indication of the
current humidity differs
from the readings of
other hygrometers.
Error Display
The monitor displays
• Make sure the Humidifying Filter, Humidifying Tray and Roller are
properly installed, and then restart the unit again.
The monitor displays
• Unplug the unit wait for one minute and then plug in and restart the unit
again.
If error is displayed repeatedly, contact SHARP
authorized service center.
Tray Partition / Float / Roller
Humidifying T
ray
At falling
The Tray Partition, Float
or Roller comes off.
• Follow the steps below to mount the Tray Partition, Float or Roller:
The Humidifying Tray
cannot be pulled out.
• Hold the Humidifying Tray up slightly and pull it out.
When the main unit falls
down during humidification
operation or when tank is
filled with water.
• If you lay down the main unit during humidification operation (when
the main unit is filled with water), stop operation immediately and
unplug the unit. Contact SHARP authorized service center for
checking.
Roller
(Do not disassemble)
Float
Float
Sectional view
Tab
Float
Put the Float
under this
projection Put the Float
tab into the
hole
Put the other
tab of the Float
into the hole
Hang the Roller on the projection of the
Humidifying Tray in the arrowed direction.
Be careful not
to mount the
Roller in a
wrong
direction.
KC-JG20A(単ページ).indd 28 2016/10/12 10:17:50