Sharp KC-JG20A, Руководство по эксплуатации

Страница: 11 / 64

ENGLISH
E-8 E-9
PREPARATION
Be sure to install filters before plugging the unit.
Filter Installation
Back Panel
Upper tabs (one each
at right and left)
Active Carbon & Silica Gel Deodorizing Filter
Active Carbon &
Silica Gel
Deodorizing Filter
Active Carbon & Silica Gel
Deodorizing Filter
HEPA Filter
HEPA Filter
HEPA Filter
Tag
Tag
No difference on both sides
Click
Fill the Water Tank
Fill tap water in the Water Tank to operate the unit in the Clean Air & Humidify mode.
Remove the
back panel
to take the
filters out.
• The filters (2 types) are
found in the main unit.
Take filters (2 types)
out of plastic bags
Tag surface should be
attached to the front side
Mount the
back panel
Lower tabs (one each at
right and left)
Handle of
water tank
Water tank
Press down the
Handle of Water Tank,
and then pull the
Water Tank out
• Be careful, do not let water spill over.
Tank cap
Water tank
Fill water
Unscrew the
Water Tank Cap
and fill tap water
in the Water Tank
• Before filling water, drain the remaining
water in the Water Tank and then rinse
it by shaking with a small amount of
fresh tap water.
The Water
Tank is
self-standing.
Click
Tighten the
Water Tank Cap
Install the Water
Tank
• Tighten the Cap firmly to make
sure no water leaks out.
• Be sure to wipe off water droplet
on the Water Tank.
• Take care not to get fingers caught
between the main unit and Water
Tank.
• Firmly hold the main unit for
mounting the Water Tank.
• Use tap water only. (Otherwise, breed of bacteria may occur)
• Do not fill hot water (≥ 40°C), aroma oil, chemicals, dirty water, detergent or aromatic
substances into the Water Tank. (Otherwise, cracks and/or water leakage could result)
Caution
• Pull the tag of the HEPA
filter out to the Active
Carbon & Silica Gel
Deodorizing Filter to
make it easy to remove it.
Install the filters
in order from the
HEPA Filter to the
Active Carbon &
Silica Gel
Deodorizing
Filter.
KC-JG20A(単ページ).indd 11 2016/10/12 10:17:37