Sharp FU-28H-S, Руководство по обслуживанию

Страница: 31 / 36

31
FU-28H-S
4 CLEANING THE PLASMACLUSTER UNIT ELECTRODES
»
Soak a cotton swab with cleaning alcohol and use it to wipe off the electrodes.
Do not directly touch the electrodes with your fingers while doing this.
Also make sure no foreign matter gets into the circled areas.
5 CLEANING THE POWER PLUG
(1) Use a soft, dry cloth to clean the power plug.
(2) After cleaning, make sure there is no dust or debris on it.
*Do not use the power plug if the prongs are loose.
Doing so could cause a malfunction. Contact a dealer or the service company.
6. ASSEMBLING THE DISASSEMBLED PARTS
(CLUSTER MAINTENANCE COVER, FAN AND FILTER CASE)
(1) Use the 2 screws to reattach the cluster maintenance cover.
(2) Install the dry fan as follows.
a) In the following order place the sitting washer, fan, spring washer, and nut on the motor shaft.
b) Tighten the nut until the spring washer flattens out.
CAUTION : Do not press down on the outer edge of the fan while tightening the nut.
(3) Install the intake guard with 4 screws.
(4) Place the filters into the filter frame and install the filter frame into the main unit. (Refer to P. 26.)
(5) Place the front panel.
7 INSERT THE POWER PLUG INTO THE OUTLET
»
Make sure the power plug is completely inserted into the outlet.
8 OPERATION CHECK
(1) Use the buttons on the side of the main unit and the remote control to make sure it works properly. (Check to
make sure the operation lamps turn on and off.)
(2) Check for abnormal sounds during operation.
If there is an abnormal sound, the fan might not be installed properly.
Recheck the fan installation. If this does not eliminate the sound, do not use the air purifier and contact the dealer
or service company.