Sharp AR-5618N Скачать руководство пользователя

Страница: 38 / 93

AR-5618S SIMULATIONS 7-8

：

'11/Jul/22

SPF jam total counter clear
(Only when the SPF/RSPF is
installed)

When the [START] key is pressed, the SPF jam total count value is reset to zero and displayed on the
7-seg display. When the [Interrupt] key is pressed, the machine goes into the sub code input standby
mode. When the [CA] key is pressed, the simulation is terminated.

Scanner mode counter clear
(Except for AR-5618S/AR-5620S)

When the [START] key is pressed, the scanner mode count value is reset to zero and displayed on
the 7-seg display. When the [Interrupt] key is pressed, the machine goes into the sub code input
standby mode. When the [CA] key is pressed, the simulation is terminated.

Main motor operation check
(Cooling fan motor rotation check)

When the [START] key is pressed, the main motor (together with the duplex motor for the duplex
model) is driven for 30 sec. At that time, to save toner consumption, if the developing until is installed,
the developing bias, the main charger, and the grid are outputted. Since, in that case, laser discharge
is required when the motor stops, the polygon motor is driven simultaneously. Check if the
developing unit is installed or not. If it is not installed, the above high voltage is not outputted and only
the motor is rotated. After completion of 30 sec operation, the machine goes into the sub code input
standby mode.
*

This simulation must not be executed by forcibly turning on the door open/close switch.

Auto developer adjustment (Initial
setting of toner density when
replacing developer)

To execute this simulation, the following procedures must be performed.

<Procedures>
1)Turn OFF the power of the machine.
2)Open the front cover.
3)Install the DV unit and toner cartridge.
4)Turn ON the power of the machine with the cover opened.
5)Enter Sim25-02. (Entered value display section: "CH" is displayed. Start LED: OFF)
6)Close the front cover. (Entered value display section: "--" is displayed. Start LED: ON)
7)Press [START] key to execute Sim25-02.

When [START] key is pressed, the main motor rotates for 3 minutes to determine the toner sensor
reference value and clear the developer rotation time as well as to clear the developer counter.

When the operation is completed normally, the ATC sensor reference value is displayed on the
entered value display section. If an error occurs, one of the following indicators is lighted.

This simulation must be executed only immediately after installing developer, Do not execute this
simulation for any developer which has been used.
If the machine goes into the warm-up state before completion of this simulation, there is a possibility
that toner may be supplied to the developer during warm-up. In such a case, therefore, the developer
must be replaced with new one.

Polygon motor operation check

When the [START] key is pressed, the polygon motor is rotated for 30 sec. After completion of 30 sec
operation, the machine goes into the sub code input standby mode.

Size setting

Enable/Disable setting of FC (8.5" x 13") size detection and Mexican legal size detection.
Press [Density Select] key to change over the lighting lamp, and enter the code number to set the
document size detection.

Detection size when FC (8.5" x 13") and Mexican legal size documents are used.

For the other destinations, this setting is disabled.

Main
code

Sub

code

Contents

Details of operation

LED

Display mode

Misfeed indicator
Paper required indicator

EL trouble
EU trouble

LED