BK-T080III (vertical) User’s Manual
- 35 -
7.2.3 Problems during paper out
Problems
Possible reasons
Solutions
The printer stops
printing and warns
errors during printing.
Paper end;
Paper jams in cutter;
Dust or wastepaper
covers the paper near
end sensor.
Install a new paper roll;
Check if there are sundries in cutter
path;
Clean the paper near end sensor.
Table 7.2-3 Problems in paper out
Note: Contaminated paper may cause detection failure.
7.2.4 Other problems
Problem
Possible reasons
Solutions
LED does not light and
printer does not work.
The printer is not
connected with the power
correctly.
The printer isn’t turned
on.
Connect the printer with power
correctly.
Turn on the printer.
The printer does not
work after receiving
commands.
Printer is in error status.
The communication cable
is not connected well.
Interface setting is wrong.
Remove the errors(
＊
)
Make sure the communication cable
is connected correctly.
Set the interface again according to
the self-test page.
Table 7.2-4 Other problems
Note:
Paper near end alarm acts only as a prompt for users, not an error status. Therefore when this alarm
is given, printing task can still be sent.
