BK-T080III (vertical) User’s Manual
- 12 -
4. Installation and suggestion
4.1 Unpacking
Open the carton and check whether all items listed on the packing list are included or have any damages.
In case of damages or missing items, please contact your dealer or the manufacture for assistance.
Caution:
z
Decide whether the Presenter weight shaft should be installed according to the paper type used.
Detailed parameters please refer to
2.2 Paper specification
.
4.2 Adjusting paper near end sensor
After opening the package, the printer has finished the assembly. But the paper near end sensor should be
adjusted before the printer is put into use.
4.2.1 Detection range of paper near end sensor
The paper remains is influenced by the following factors: position for installing the paper near end sensor,
paper roll core shaft ID and paper roll core shaft OD.
Figure 4.2-1 Adjusting position of paper near end sensor with standard paper holder
4.2.2 Paper near end sensor adjusting method
The default position of paper near end sensor is the detecting position of
φ
25 paper roll (see Figure 4.2-1
for the salient point in the middle), and the diameter of paper roll detected is 39.5mm. If it needs to be
adjusted, refer to the following method:
When using paper roll whose ID is 18mm, push the paper near end sensor fixing bracket in the paper roll
shaft direction with hand until it cannot rotate. Then the paper near end sensor fixing bracket will indicate
position 32, meaning that the diameter of paper roll detected is 32mm;
When using paper roll whose ID is 40mm, push the paper near end sensor fixing bracket against the paper
roll shaft direction with hand until it cannot rotate. Then the paper near end sensor fixing bracket will
indicate position 52.5, meaning that the diameter of paper roll detected is 52.5mm;
