SF TECH Neoprene Classic, Руководство пользователя

Страница: 9 / 40

9
ENGLISH
6. FITTING AND USAGE
PRE-DIVE
‹ Before each dive, make sure the suit is in good working condition.
‹ Check the overall condition of the suit, looking for tear, hitch or hole.
‹ Inspect the seams, making sure none of the threads are broken.
‹ Control the wrist and neck seals. If a seal is cracked, sticky or worn, replace it before diving.
‹ Make sure the inflator, dump valve and P-valve are tighten and function properly. Follow the
manufacturer recommendation.
‹ Inspect and clean the zipper. Apply some paraffin on the exterior teeth of the zipper.
‹ If necessary, dust the latex wrist and neck seal with unperfumed talcum powder.
DONNING
‹ Remove all jewelry, watch and necklace as it could tear the seals or damage the suit.
‹ Put the undergarment suitable to the environmental conditions and the type of diving activity.
‹ Ensure the protective zipper and waterproof zipper are COMPLETELY OPEN. Donning or doffing
a suit with a zipper partially open will damage the side tape and the zipper will break.
‹ Grab the crotch of the suit and fold the upper part of the suit inside out over the legs to about
waist level.
‹ Make sure the suspenders are outside of the legs, correctly attached and not entangled. The
crossover of the suspenders should be in the back of the drysuit.
‹ Step into the suit with one leg, grasp the suit material at calf level and gently ease the foot into
the boot. Pull the suit up your thigh.
‹ Repeat with the other leg.
‹ Grasp the waist of the suit and gently pull it up so that the crotch of the suit is correctly positioned
between the legs. Be careful not to put excessive force on the zipper end.
‹ Put the suspenders over the shoulders and adjust the length.
‹ Optional: Connect the P-valve.
‹ Once properly positioned from the chest down, pull the upper part of the suit all the way up to the
chest.