TECHNICAL MANUAL
data.
[Notes for ② ] If
n is outside of the specified range, the printer stops command
processing and processes the following data as normal data.
[Notes in standard made]
If d is outside of the specified range, the printer only feeds paper and
process the following data as normal data.
If the horizontal size exceeds printing area, the printer only feeds the
paper.
This command feeds as much paper as is required to print the bar code,
regardless of the line spacing specified by ESC 2 or ESC 3.
This command is enabled only when on data exists in the print buffer.
When data exists in the print butter, the printer processes the data
following m as normal data.
After printing bar code, this command sets the print position to the
beginning of the line.
This command is not affected by print modes (emphasized, double-strike,
underline, or character size), except for upside-down mode.
[Notes in page made]
This command develops bar coed data in the print buffer, but does not
print it.
After processing bar cod data, this command moves the print position to
the right side dot of the bar code.
If d is out of the specified rang, the printer stops command processing
and processes the following data as normal data. In this case, the data
butter position does not change.
If bar code width exceeds the printing area, the printer does not print the
bar code but moves the data buffer position to the left side out of the
printing area.
If height of the bar code exceeds the label, exceeding part of the bar
code is printed on the next label.
[Reference]
GS H, GS f, GS h, GS w
GS r
n
[Name]
Transmit status
[Format] ASCII
GS r
n
Hex 1D 72
n
Decimal 29 114
n
[Range]
n=1, 2, 49, 50
TITLE : WTP-100
Page72
