TECHNICAL MANUAL
M
Print mode
0, 1, 49
Partial cut(one point center uncut)
66
Feeds paper(cutting po [n x(vertical motion unit)]) , and cuts
the paper partially(one point center uncut)
[Notes for (1)
and (2)] This command is effective only processed at the beginning of a line.
[Note for (1)]
Only the partial cut is available; there is no full cut.
[Notes for (2)]
When n = 0, the printer feeds the paper to the cutting position and cuts it.
When n ≠ 0, the printer feeds the paper to (cutting position + [ n
´
vertical motion unit
])
and cuts it.
The horizontal and vertical motion unit are specified by GS P.
The paper feed amount is calculated using the vertical motion unit (
y
).
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount.
GS W
[Name]
Set printing area width
[Format]
ASCII
GS
W
nL nH
Hex 1D 57
nL nH
Decimal
29 87
nL nH
[Range]
0
≤
nL
≤
255
0
≤
nH
≤
255
[Description]
Sets the printing area width to the area specified by nL and nH
The printing area width is set to [(
nL
+
nH
x 256) x horizontal motion unit]]
inches.
Printable area
Left margin Printing area width
[Notes]
This command is effective only processed at the beginning of the line.
In page mode, the printer performs only internal flag operations.
This command does not affect printing in page mode.
If the [left margin + printing area width] exceeds the printable area,
[printable area width - left margin] is used.
The horizontal and vertical motion units are specified by GS P. Changing
the horizontal and vertical motion units does not affect the current left
TITLE : WTP-100
Page63
