SEW-Eurodrive MOVIPRO PHE Series, Руководство по эксплуатации, Страница: 39 / 100

6
Electrical installation
Using prefabricated cables
Operating Instructions – MOVIPRO
®
PHE..B-A15-.1X0..B-00
39
6.7.1 Use of third-party cables
If third-party cables are used – even if these cables are technically equivalent –
SEW‑EURODRIVE will not accept any liability and cannot guarantee compliance with
device properties or that the device will function correctly.
When using third-party cables to connect the device and/or device components, make
sure to comply with all applicable national regulations. Note that the technical features
of the device or system of devices might be affected inadvertently when using non-
SEW cables. This concerns in particular the following properties:
• Mechanical properties (such as IP protection class, cable carrier suitability)
• Chemical properties (such as the absence of silicone and halogen, resistance
against substances)
• Thermal properties (e.g. temperature stability, heating of the device, flammability
class)
• EMC behavior (such as interference emission limit values, compliance with inter-
ference immunity values stipulated in standards)
• Functional safety (approvals according to EN ISO 13849-1)
Non-SEW cables not explicitly recommended by SEW‑EURODRIVE must meet at
least the requirements of the following standards and have been permitted according
to these standards:
• IEC 60309
• IEC 61984
• IEC 60204
23576855/EN – 10/2017