SEVERIN KA 4770 -, Инструкция по эксплуатации

Страница: 9 / 58

done if the appliance has not been used for
an extended period of time, and after
descaling.
General information
- A measuring scale on the water
container facilitates filling the container
with the correct amount of clean water.
With a dual-scale, the left scale is used for
regular-sized cups of approx.125ml, while
the right scale is used for smaller cups.
Make sure that the indicated maximum
amount of water is not exceeded.
●
Do not remove the water container
unless the appliance has been switched
off. This will prevent damage to the
heating element.
●
If several consecutive brewing cycles are
required, let the appliance cool down for
approx. 5 minutes after each cycle.
●
Important note: When filling the
appliance with fresh water shortly after a
brewing cycle is completed, there is a
danger of scalding from hot water or
steam escaping through the water outlet.
Making coffee
- Filling with water:
Use the grip recess on the water container
and lift it out. Open the lid, fill the container
with the desired quantity of water and
replace the lid. Replace the container in the
appliance and push it down in to open the
valve in the bottom.
-
Inserting the paper filter:
Open the swing-out filter by pressing the
filter release and insert a
size-4 paper filter
into the filter holder, first folding down the
perforated sides of the filter.
-
Filling with ground coffee:
For each regular-sized cup (125ml), a
measure of about 6 g (= 1
1 /
2
- 2 teaspoons) of
medium or finely ground coffee will be
required. Close the swing-out filter
afterwards, ensuring that it locks into place.
-
Preparing the glass carafe:
Fit the aroma protection lid onto the carafe,
and then place the carafe into the appliance.
If correctly inserted, the lid will disable the
drip-stop mechanism in the filter holder
during the brewing cycle.
-
Starting the brewing cycle:
Insert the plug into a suitable wall outlet and
use the Start button to switch the coffee
maker on. The filtration cycle starts and the
water passes through the filter.
-
Removing the glass carafe:
Wait until all the water has passed through
the filter before the carafe is removed from
the appliance. To keep the coffee hot for as
long as possible, remove the aroma
protection lid and use the screw-in lid to
close the carafe.
-
Switching off the coffee maker:
Remove the plug from the wall outlet after
use.
Heat-retaining carafe
- For technical reasons the screw-in lid
does not close hermetically. Therefore
always hold the carafe in an upright
position when filled with coffee.
- Keeping the coffee hot: A heat-
conserving carafe accumulates heat
energy. Therefore the carafe should
preferably be filled to its maximum
capacity.
If it is only partly filled, the
temperature will not be held as
efficiently.
If you rinse out the carafe with
hot water before use, the coffee will be
kept warm for a longer time.
The interior of the heat-retaining carafe
insert consists of high quality double-walled
glass with a vacuum in-between for better
insulation. Any streaks or bubble marks
inside the carafe looking like bubbles or
scratches do not affect its functional use nor
its heat-retaining ability.
In case the glass is damaged for one or the
other reason as mentioned below, there is a
risk that the glass carafe implodes.
This
might happen quite some time after the glass
carafe has actually been damaged.
●
Therefore do not drink out of the carafe
and do not put your hand into it. Always
9