Servend FlexTower 12, Инструкция по установке и обслуживанию, Страница: 22 / 40

22
Installation and Service Manual
Program
Button
LED
Display
OPERATION
PROGRAMMING MODES
CONTROL BOARD RUN OR DISPENSE MODE
(Control Board LED Displays 0)
For finished drink, press and hold any labeled finished
drink touchpad area to manually dispense a finished non-
carbonated drink (all touchpad areas are defaulted from
factor to manual dispense mode). For flavor adder, press
any labeled flavor adder touchpad area and a one shot
stored timed dispense will occur (dispense time of flavor
adder can be changed in program mode 2).
TO ACCESS PROGRAMMING MODES
To enter programming modes, press and hold control
board program button for a minimum of 3 seconds. Con-
trol board LED displays a number (1) for manual dis-
pense mode. To select another programming mode,
press and release the control board program button once
to enter the next programming mode. Repeat pressing
and releasing the control board program button until
desired program mode is entered.
THE 6 PROGRAMMING MODES ON FLEXTOWER
CONTROL BOARD
Program Mode 1= Manual Dispense Mode
Program Mode 2= Timed Dispense Mode or Flavor Adder Mode
Program Mode 3= Water Calibration Mode
Program Mode 4= Syrup Calibration Mode
Program Mode 5= Touchpad Configuration Mode
Program Mode 6= Touchpad LED Light Sequencing Mode
TO EXIT PROGRAMMING MODES
To exit programming modes and to save programming
mode changes, press and hold control board program
button for a minimum of 3 seconds. Control board LED
displays (0) for run or dispense mode.
MANUAL DISPENSE MODE
(Finished Noncarbonated Drink Dispensed)
Once in program mode (1), control board LED displays
(1). Press any touchpad selection area two times in less
than three seconds and selection area LED lights will blink
twice to indicate the touchpad area has been programmed
for manual dispense. The procedure can be repeated for
other touchpad selection areas needing programmed for
manual dispense. After all designated touchpad areas
have been programmed for manual dispense either enter
another program mode or exit the programming modes,
which will save programming mode changes.