SEON Explorer EX8Plus Mobile, Инструкция по установке и эксплуатации

Страница: 94 / 104

Troubleshooting
6–2 700-0048 R003
6.1. Troubleshooting the EX8 Plus System
The EX8 Plus System is designed for high reliability of operation. If, however,
you have any problems with your system, read this Troubleshooting chapter. If
you cannot resolve the issue, contact Customer Service at Seon Design.
Symptom Possible Cause and Solution
All problems. Many system problems are caused by issues with the power
supplied to the DVR. Check the following:
• The voltage to the system may be too low. Check the
LOW
V
OLTAGE
indicator on the back of the DVR. See “Back
panel” on page 1–7 for location of the
LOW
V
OLTAGE
indicator.
• The power harness from the DVR must be connected as
close to the battery as possible. Check the wiring to the
battery. See “2.6. Step 5: Connecting the Ignition Harness,
Power Harness, Fuses and Fuse Holders” on page 2–9.
• Check the in-line fuses and fuse holders. If a fuse is
blown, determine the cause before replacing it.
The DVR does not power on. • Is the internal temperature below 40°F (4°C)? Check the
flashing Low Temperature indicator on the back panel of
the DVR. The DVR temperature must be above 40°F to
operate. The DVR internal heater can help to quickly raise
the internal temperature of the DVR.
• Are the power and ignition harnesses plugged into the
DVR securely?
The DVR turns on but does not start
recording. • Check the ignition wiring from the power input harness. Is
the yellow wire connected to an ignition switched circuit.
• Is the hard drive installed properly with the key in the
locked position on the front panel?
• Is the temperature below 40°F? Check the flashing Low
Temperature indicator on the back of the DVR. Wait for
the DVR to warm up and start recording.
• Is the temperature above 122°F (50°C)? Check the
flashing
LOW TEMPERATURE
indicator on the back of the
DVR. Check the fan filter on the back panel for any
blockage. If necessary, replace the fan filter. See “5.1.3.
Replacing the Fan Filter” on page 5–2.
• Check the battery voltage.
• Check the settings for Record Delay-On time in the
Record menu. See “3.2.4. Using the Record Menu” on
page 3–10.
• Are the timers on?