SEON Explorer EX8Plus Mobile, Инструкция по установке и эксплуатации

Страница: 30 / 104

Installation
2–8 700-0048 R003
To connect to the back of the DVR:
1. Plug the 6-pin mini-DIN connector from each camera into the mating
connector on the back of the DVR. See Figure 2-4.
2. Plug one end of the Smart-Link-to-DVR connection harness into the
POWER
IN
connector. The connectors on the harness are identical so that either end
can be plugged into either device. See Figure 2-5.
The other end of the Smart-Link-to-DVR connection harness is connected
once the Smart-Link module has been installed. See “2.7. Step 6: Installing
the Smart-Link™ Module” on page 2–10.
3. Plug the power harness into the 2-pin power input connector. See Figure 2-6.
4. Connect the red positive and black negative wires to the battery when
connecting the power harness. See “2.6. Step 5: Connecting the Ignition
Harness, Power Harness, Fuses and Fuse Holders”.
5. If an optional external microphone is being used, plug the power connection
into either
POWER 1
or
POWER 2
.
6. Plug the
RCA
connector into the
AUDIO IN
1
or
AUDIO IN
2
jack. See “2.4.1.
Checking the Camera Cable Connections” on page 2–5 about disconnecting
the audio from a camera when using the external microphone.
7. Push the cables into the cable retainers on the back of the DVR brackets and
slide the DVR into the lock box.
Figure 2-5
Smart-Link-to-DVR connection harness
Figure 2-6 Power harness
Important:
Take care not to pinch or bind any cables when sliding the DVR into the
lock box.