SEON Explorer EX8Plus Mobile, Инструкция по установке и эксплуатации

Страница: 25 / 104

Installation
700-0048 R003 2–3
Longer cables To customize your installation, longer cables are available by contacting your
sales representative at Seon Design.
Important note
2.2. Step 1: Installing the Lock Box
The lock box has a door and lid which will need to be removed in order to secure
the base in its location. The lock box can be mounted either on the floor or
underneath a seat.
The lock box can be installed horizontally (see “2.2.1. Horizontal Installation”).
Four mounting points are located on the base of the lock box for securing the unit
and raising the unit off the mounting surface by 3/16".
The lock box can be installed vertically (see “2.2.2. Vertical Installation” on
page 2–4). Three mounting points are located on the back of the unit for securing
the unit and raising the unit off the mounting surface by 3/16".
2.2.1. Horizontal Installation
To install the lock box horizontally:
1. Unlock the door with the lock box key provided and remove it from the base
of the lock box.
2. Slide the DVR out of the lock box by pulling on the two bracket tabs at the
front of the DVR.
3. Detach the lid from the lock box by removing the two retaining screws on
either side of the lid near the front of the lock box.
4. Determine whether the power and camera cables will enter the lock box on
the left or the right side. Swap the cable grommet and the hole plug, if
necessary. See Figure 2-1.
5. Use the four #10 × ¾" sheet metal screws or #10 × 1" self-drilling screws to
secure the base of the lock box to the floor.
Important:
If you are mounting the lock box under a seat, please contact your Seon
Design sales representative or dealer for information on the Underseat Mounting Bracket
Kit before starting the installation.
Important:
If you are mounting the lock box vertically, please contact your Seon
Design sales representative or dealer for information on the Vertical Mounting Bracket Kit
before starting the installation.
Important:
If you are mounting the lock box under a seat, contact your Seon Design
sales representative or dealer for information on the Underseat Mounting Bracket Kit.
Important:
It is not recommended that the lock box be installed on its left or right side
where the cables enter the unit.