Hardware Configuration Instructions
for TTRF Infrastructure
©
SENSITECH INC
REV A
9/6/2005
8
16) Enter the Hex GLN number starting at byte [7 of 12]. The following screen should be
displayed.
Hex GLN Number in Hyper Terminal
17) To clear the GLN and turn the Signpost back in to a Repeater/Signpost, use the “c”
command, followed by the “e” command.
18) You can also configure the Signpost to be a Repeater/Signpost, use the “r” command,
followed by the “e” command.
19) Use the “*” command to unbind a Repeater that has previously been “Bound” to a specific
TTRF Gateway.
Note:
You can also use the “Unbind” button (SW1) on the
Repeater/Signpost Motherboard to unbind from a TTRF Gateway.
