9
10/06/11 Revision 1.1
3.5
Keypad and LED’s
(1)
Output LED (Green):
This LED will be on any time the BBS is providing output to the load.
The operating modes that this can occur are: “BACKUP”, “BUCK1”, “BUCK2”, “BOOST1”,
AND “BOOST2”.
(2)
Fault LED (Red):
This LED will be on any time that the BBS has detected a “Fault”. Look at
the third line of the LCD for information on the fault.
(3)
Alarm LED (Yellow):
This LED will be on any time that the BBS has detected an “Alarm”.
Look at the third line of the LCD for information on the alarm.
(4)
Esc key:
This key is used to escape from changing settings and to jump to higher menus.
(5)
Inv key:
By pressing this key you can enable or disable the inverter of the BBS.
(6)
Navigation keys:
Press these keys to navigate through the menu system. You also use these
keys to change values in the “Configuration” and “System” menus.
(7)
Enter Key:
Pressing the “Enter” key will take you into menus and allow you to change and save
settings.
(8)
Rotatable Display:
Remove these four screws to rotate the display for vertical mounting.
Pressing both the right and left arrow keys simultaneously will reset all of the event counters and the run
time meters (Inverter, Buck, and Boost).
2
3
4
5
6
7
1
8
