Sennheiser Digital 9000, Инструкция по эксплуатации, Страница: 57 / 130

Digital 9000 | 55
Using the EM 9046
“ sys ” operating mode – Configuring the system
In “ sys ” operating mode, you can configure the transmitters and the
receiver.
Overview of the “ sys ” menu
Main menu “System setup” Page
Frequency scan
Performs a frequency scan of all
8 frequency ranges
56
Range detail scan
Performs a frequency scan of
the active frequency range
Assigns frequency presets to
the channels
60
Audio output level Adjusts the output level 63
Word clock Configures the word clock 64
Cable attn Displays the cable attenuation
between booster output and
RF input of the EM 9046 and
compensates for it 64
Load config Loads a configuration 65
Save config Saves a configuration 65
Network Configures the network 66
Brightness Adjusts the brightness 66
Service setup
Calls up the extended menu
“
Service setup ”
–
Extended menu “Service setup” Page
System setup
Calls up the main menu
“
System setup ”
56
Factory reset
Loads the factory default
settings
67
Date & time Adjusts the date and time 68
Op hours Displays the operating hours 69
Log Displays the event logs 69
System check Displays the system status 69