Sennheiser Digital 9000, Инструкция по эксплуатации, Страница: 67 / 130

Digital 9000 | 65
Using the EM 9046
“Load config” – Loading a configuration
The “ load config ” menu item allows you to load up to 10 saved settings of
your system configuration (see also the “ save config ” menu item).
In addition, you can ...
• load the last configuration saved (“ last ”).
• load the default configuration (“ defaults ”). In this case, the settings of
the menu items mentioned in the section “save config” are reset to their
factory defaults.
“Save config” – Saving a configuration
Via the “ save config ” menu item, you can save your system configuration
on up to 10 storage memories.
The settings of the following menu items are saved:
Display Status of the cable attenuation
“ ok ” The cable attenuation has been measured and is
automatically compensated for.
“ Too high ” The cable attenuation has been measured and is too high. It
cannot be automatically compensated for. The reception of
weaker signals is compromised.
왘
Check and optimize the installation between the EM 9046
and the antenna boosters.
Always use GZL 9000 system cables to obtain optimum attenuation
values.
Menu Menu item Page
Main menu
“
System setup ”
Output level 63
Word clock 64
Network | name of the network 66
Network | IP settings 66
Brightness 66
Extended menu
“
Service setup ”
Date & time | selected time zone 68
defaults
load config
modified