Sennheiser Digital 9000, Инструкция по эксплуатации

Страница: 74 / 130

Using the EM 9046
72 | Digital 9000
If you have extended the EM 9046’s hardware configuration, this is dis-
played in the “
hw setup ” menu item with the status “ added ”:
In both cases, the “ Press SET to confirm ” button is highlighted in blue.
In the “ hw setup ” menu item, you confirm modifications as follows:
왘
Press the jog dial.
The “
Press SET to confirm ” button is framed in blue and “ Press save to
confirm hw setup ” appears in the menu selection.
왘
Press the button
F
.
“Firmware” – Displaying the hardware versions/firmware
versions and updating the firmware
If you update the EM 9046 receiver’s firmware using the WSM software,
the current firmware versions of the 9000 series boosters and transmit-
ters are also stored on the receiver.
Via the “ Firmware ” menu item, you can display the firmware versions of
the receiver, the boosters and the transmitters and update the firmware
of the boosters and the transmitters.
The currently installed firmware version of the EM 9046 is displayed in the
menu selection (see above).
p
Slot Module Type State
RX1 EM 9046 DRX ok
RX2 EM 9046 DRX ok
RX3 EM 9046 DRX ok
RX4 EM 9046 DRX ok
RX5 EM 9046 DRX ok
RX6 EM 9046 DRX ok
RX7 EM 9046 DRX ok
RX8 EM 9046 DRX ok
MAN EM 9046 DAN ok
OUT1 EM 9046 AAO ok
OUT2 EM 9046 DAO added
ASP EM 9046 ASP ok
EM9046_3_0_2_11476
firmware
Update to firmware:
Antenna booster
12-05-07-09
RF IN A:
Firmware:
AB9000_4
12-05-07-09
RF IN B:
Firmware:
AB9000_4
12-05-07-09
Start update mode
Transmitter SCAN ONLY MODE
Transmitter:
Firmware:
New firmware: