In the image below you will see the Stabiliser Leg Settings. ALL of these markings relate
ONLY to the CURVED SETTINGS.
The Numbers 4 / 5 / 6 are beside holes with a circle around them and relate to the 4 / 5 / 6 (C) markings on the legs.
The Holes with the Cross Hair over them relate to the Half Sizes 4.5 and 5.5
The Holes with no marking DO NOT have leg markings. These are settings 5.25 and 5.75. These are used with the
Extension to give you additional settings at the HIGHER END – Approx 690 and 760 High. Please refer to the table below
for the FULL Range of Height Settings available.
The HOLE with the
SQUARE is HOME
– THE SECOND SECURITY BOLT ALWAYS GOES INTO THE SQUARE.
In this ILLUSTRATION we are still creating a 550 High Curved Ramp so the end of the bolt in the Stabiliser goes into the Cross
Hole between Number 5 and 6. Essentially 5.5 (representing 550 mm high). Place the security bolt through the Stabiliser SLOT
and into the hole with the SQUARE as shown below. Tighten the Bolt to secure the leg! Repeat the same for the other Stabiliser
on the otherside.
NUANCES OF THE FLY
You may notice that the Stabiliser leg settings have a number 4 BEFORE the 5. This may not seem logical at first sight or a
mistake. The geometry is such that the curve created by the movement puts the 4 before the 5! You will see how this works if
you try and use this position.