Model SSD1-HS
508.366.1488 | semshred.com Page 14
of 23
7.3
Accessing the Cutting Chamber
The drive belt should be inspected periodically for excessive wear or damage. The cutting chamber is
where the shredding occurs. One might need the access it to clear a jam, service the knives, or adjust
the drive belt. Follow the steps below to access the cutting chamber:
1.
Tools Required:
a.
7/16” socket wrench
b.
Phillips head screwdriver
c.
5/32” Allen wrench
2.
De-energize the unit using proper LOTO procedures.
3.
Remove the feed assembly (two bolts under the feed assembly and inside door) using Phillips
head screwdriver or 7/16” socket wrench.
Figure 5.0:
Feed assembly
4.
Lift Feed Assembly up from the front while pulling it towards the operator of the machine.
5.
Remove the 12 #10-32” screws using 5/32” Allen wrench in the bottom of the hopper.
Figure 5.1:
Removing hopper
Remove
Feed Assembly
Hopper
Cutting Chamber
