Model SSD1-HS
508.366.1488 | semshred.com Page 19
of 23
12.
Attach front and rear deflectors as shown with eight 5/16”-18 x 1 1/4" hex bolt and 5/16” lock
washer.
Requires 1/2" wrench.
13.
Do a final check of bolt torques, assembly bolt tightness, and knife gapping.
14.
Contact SEM for details about service and re-sharpening.
Note: Knives must be sharpened as a complete set (2 bed knives and 3 rotor knives) and can be
sharpened two or three times provided they are not damaged or overused between sharpening,
which will reduce the life of the knife. Failure to sharpen or replace knives will result in excess
dust, frequent jamming of cutting chamber, reduced throughput, excess vibration, and
increased noise throughout the machine. Contact SEM for sharpening and service plans.
Front
deflector
Rear
deflector
Figure 11
Figure 12
