Selectronic 2000 EVO1, Руководство по установке

Страница: 6 / 20

EN
▫ Remote control inputs: this is a low voltage input having impact only in ’Remote control mode’ of control unit: in this mode, opening or closing contacts put to this
input shall switch the heating radiator (it can be set in software, how)
▫ Zone internal temperature sensor inputs: low voltage analogous inputs, which TEMP-IN or TEMP-OUT type sensors can be connected to
◦ By using TEMP-IN sensor, the ’Overtime heating’ mode can be activated, by which the operator can request one supplementary hour of heating after the
heating unit switched off
◦ By using TEMP-OUT sensor, this mode is disabled, and cannot be activated
◦ Inputs ’Inner1’ and ’Inner2’:
· when using one internal sensor, there is no importance, which input being connected to
· when using two internal sensors, an average temperature will be reckoned from measured data
· ’Overtime heating’ mode can be activated from both inputs (by using both ’temp-in’-s)
▫ External temperature sensor input: low voltage analogous input, which TEMP-OUT type sensor can be connected to
◦ it is not absolutely necessary to use an external heat sensor, but the software shall be set in any case, whether used or not
◦ by using external sensor, you will be given the possibility to use ’Optimisation heating-up’ mode
▪ Connection of auxiliary panel:
▫ You shall exclusively use auxiliary panels which being compatible with EVO control unit, information thereof can be obtained in the description of complementary panel
▫ Insert complementary panel into 10 pin serial connector of control unit as shown in figure (Fig. 2.), and check then correctness of connection
▪ Power up the unit:
▫ Insert battery into battery holder of control panel
▫ Connect serial connector of flat multicore cable of box cover into lower control panel until fixation pins snapped into their resp. position (the connector can only be
assembled in one single position, no reverse connection is possible)
▫ Check all connections and contacts once again
▫ Ensure that no one is staying near to control unit and to connected equipment and by putting the equipment into operation, no personal injury or material or property
damage can occur
▫ Put control unit onto power supply
▫ Controls 0mark their waking up by loud beep
▪ Performing/inspection of parameter settings:
▫ Control unit is delivered with preset factory parameters, these values shall be checked or corrected for adjusting to local site characteristics
▫ Carry out software settings or fine tunings according to the chapter ’Software settings’
6
Fig. 5A: Connection of Terminal Blocks - EVO1
Fig. 5B: Connection of Terminal Blocks - EVO2