12
5. INSTALLATION
5.1 SETTING UP THE LED LIGHT SOURCE
Place the LED light source on a stable surface (cart, counter, stand, etc.).
NOTE: Avoid places where the light source may be splashed with liquid.
Absolutely DO NOT use in any environment with explosive or flammable gases.
DO NOT block the venting grids of the LED light source.
Make sure the power switch is in OFF position.
Connect AC power cord to the power inlet located on the rear panel of the light source.
CAUTION:
Use only cords provided with the light source.
Plug the AC power cord into a wall outlet using the three-prong plug supplied with the unit.
CAUTION:
To prevent electric shock, connect power cords of peripheral equipment through medical isolation
transformers.
NOTE: When using medical isolation transformer, be sure to check the transformer power ratings.
Make sure that the power cord is connected to the main power with three-prong plug (USA use UL2601-1 rated
isolation transformers and/or power strips only).
CAUTION:
When used in clinical or residential areas near radio or TV units, this equipment may be subjected to radio
interference. To avoid adverse electromagnetic effects, DO NOT operate this equipment near RF energy equipment.
5.2 CONNECTING THE FIBER OPTIC CABLE
Turn intensity control to the minimum setting. Connect the light cable to the instrument and then plug the light cable
endfitting into the port on the front panel.
6. OPERATION
6.1 POWERING UP THE LED LIGHT SOURCE
To operate the LED light source: Turn on the power switch. The indicator on power switch will light.
6.2 LIGHT BRIGHTNESS DISPLAY AND CONTROL
The light brightness adjustment enables the user to obtain a brighter or darker illumination of the object of observation.
Adjust the light intensity by turning the intensity control knob.
7. CLEANING
NOTE: Always disconnect the power cord before cleaning the system.
The unit can be cleaned with any cleaning agent, which is used for external cleaning of electric equipment, according to
instructions given by the manufacturer of the cleaning solution.
Do not allow excessive moisture or liquids to come in direct contact with the unit.
Do not use cleaning agents that are not permitted for use with plastics, i.e., ammonia, acetone, salty acids (HCl), etc.
Do not allow cleaning agents or liquids to enter the unit outlets.
