Version: 02/02/05 Page 11 of 22
10. Change Web Page Pass Word
To change the Juice Box Username and Password use the following procedure:
•
Connect your computer to the Juice Box via the RS232 interface using a standard serial
cable.
•
Start up the terminal adapter program.
•
Hit the Enter key then type “set pw”, (case insensitive), and press the Enter key again.
The Juice Box will respond with “ENTER USER NAME”.
•
Enter the user name and press Enter. (All characters are valid except spaces). If no
characters are entered the user name will be blank. The Juice Box will respond with “
ENTER PASSWORD”.
•
Enter the password. The Juice Box will respond by displaying both the User Name and
the Password.
11. Port Configuration
The Juice Box PoE ports can be configured for user defined port designations, device detection
and maximum output power allowed. The factory default configuration is all ports set to:
•
Port designation defaults to port number
•
802.3af detection only.
•
Maximum power of 15 watts.
Port Designations
The port designations are user defined up to a maximum of 32 characters
.
Device Detection
•
802.3af Only
– The Juice Box will supply power to the device only if it presents a valid
802.3af PD signature.
•
Legacy
and 802.3af
– Power will be supplied to the device if it presents an 802.3af
signature or if it has an impedance between approximately 4,000 ohms and 60,000
ohms. (This detection should be used ONLY if the device connected to the port is
compatible with power connections to 4/5 and 7/8 with 48 volts on Pins 4/5 and 48 volt
return on Pins 7/8).
•
Disabled
– Power is never applied to the port.
•
Forced On
– Power is always applied to the port. (This setting should only be used by
a qualified technician as damage could occur to a non-compatible device.)
