Sega SHOOT THIS WIN THIS, Руководство по обслуживанию

Страница: 49 / 93

44
CONTROL
UNIT
10
• When wor�ing with the product, be sure to turn the power off. Wor�ing with the
power on ma� cause an electric shoc� or short circuit.
• Be careful not to damage the wires. Damaged wires ma� cause an electric shoc�, short
circuit or present a ris� of fire.
• Exercise due caution in performing soldering wor�. If soldering iron is handled
carelessl�, there could be fires or burns.
• When fastening plastic parts, be careful not to tighten screws or nuts excessivel�. If
these are tightened to excess, parts could be damaged, resulting in in�uries from
fragments, etc.
• After the unit has been disassembled and reassembled again, chec� carefull� to be
sure that there are no gaps or rattling at the �unctions and that the trigger can be
operated smoothl�. If there are gaps or rattling, or if operation is not satisfactor�, the
pla�ers could get fingers or hands caught, resulting in in�ur�.
• Be sure to inspect gun surfaces for crac�s and damage. Pla�ers could be in�ured if the�
pla� when the unit is crac�ed or damaged.
• Assemble so that there is no gap between the L and R covers. If there is a gap or
rattling, the pla�ers could get fingers or hands caught, resulting in in�ur�.
• Once the product has been disassembled, use slac� preventive agent (product No. :
090-0012-N). Coat screws with suitable amounts of this agent and then tighten them.
If this agent is not used, the product might start rattling or come apart.
• Use the slac� preventive agent prescribed in these instructions. If an� other agent is
used, there could be chemical changes that inhibit the use of screws and part surfaces
could be damaged.
• Be careful not to damage or lose small parts or screws.
• When a part has been replaced, be sure to alwa�s ma�e ad�ustments and chec�
conditions in �est �ode.
If the gun does not operate satisfactoril� and ad�ustments in �est �ode are ineffective, it could be that
parts inside the gun have been damaged.
Follow the steps given below to remove the gun, then ta�e it apart and replace parts.
�o replace parts in the gun, detach the L and R covers of the outer part.
Because internal parts are inserted on the R cover side, wor� with the R cover facing downward.
CONTROLLER UNIT 10