Sega Ghost Squad Deluxe, Руководство по обслуживанию

Страница: 72 / 150

71
6. CONTROL UNIT (GUN CONTROLLER)
•
In order to prevent any electric shocks or short circuits, be sure to turn the
power off before performing any work that involves touching the interior
parts of the product.
•
Be careful not to damage the wires. Damaged wires may cause electric
shocks or short circuits, or present a risk of fire.
•
Be very careful when soldering. Handling a soldering iron carelessly may
result in a fire or a burn.
•
When securing the plastic-made parts, do not excessively fasten screws
and nuts. Failure to do this may damage the parts, and fragments resulting
from damage may cause injury.
•
When reassembling the Gun Controller, be sure to check the connecting
portion and the trigger, etc. If the reassembly work is insufficient and/or
incorrect, fingers may be caught and result in injury.
•
The solenoid on the Control Unit (Gun Controller) may become hot. Take
care as there is a risk of accidental burns.
•
Do not cut the tie belt securing the wires in the Control Unit (Gun Controller).
Cutting the tie belt may cause malfunctioning of the wire connection. If you
cut the tie belt when replacing the wire etc., be sure to secure the wires
using a new tie belt as before.
•
Follow these directions carefully to avoid damaging or losing small parts.
In cases where the gun's operation is unsatisfactory or the gun sight deviates from the direction in which
the control unit is pointed, the gun's interior parts may have been damaged. Replace the parts by
disassembling the gun with the procedure described below. Also, be sure to perform a sighting check in
the test mode when the gun parts are replaced.