SEFAM DreamStar Auto, Руководство для пациента

Страница: 10 / 42

en GB – 10 DreamStar Intro, Info, Auto patient manual
Operation
Filling the water chamber (if included)
1. Switch off the device and remove the patient
tubing. Press with your fingers at the "Push"
marking on the top of the unit to separate
the water chamber from the device.
2. Tip the tank back and remove the tank from
the device.
3. Fill the water chamber (through the upper orifice) to the maximum level mark.
4. Reattach the water chamber to the rear of
the device.
CAUTION
•
Be careful not to exceed the maximum fill level.
• Do not add any other product to the water in the water chamber.
•
Do not use alkaline solution (physiological saline solution).
• Use only room temperature water; do not fill the water chamber with hot or chilled water.
Starting Treatment
1. Put your mask on as described in the user instructions. If the Auto ON feature has been enabled by your
health care provider, the device will start during your first breathings in the mask (except with
DreamStar ™ Intro / Intro Evolve).
2. Otherwise, to start treatment, press the On/Off button . The device screen displays the delivered
pressure.
3. If the message “MASK UNPLUGGED" displays on the screen, this means that the mask is not connected
properly. Reposition your mask correctly to eliminate the leaks, and press the On/Off button or
the ramp button . The device will restore the set pressure and the message "MASK UNPLUGGED"
will disappear.
4. Lie down and place the tubing so that it can follow your movements while you sleep.
Water Chamber
"Push" marking