SEDLBAUER speed card, Руководство пользователя

Страница: 9 / 97

Manual ISDN Adapter - Startup /Technical Requirements / Hardware Installation 9
4.2 Hardware installation
4.2.1 Installation of „speed win PCI“
Caution:
First disconnect the PC from the 230 V mains!
To install the ISDN controller, open your PC as described in your manual supplied with your computer. Insert the ISDN
adapter in a vacant PCI bus slot.
Should you have any problems or questions, please contact your computer vendor.
speed win PCI
Figure 4.2.1
4.2.2 Installation of „speed card“
As speed card is no
plug & play
adapter and you have to put in the E/A address as well as IRQ manually, the
CAPI drivers should be installed before speed card.
Please note the IRQ and I/O-address on installation.
After installing the driver software separate your PC from the 230 V net!
On default the second parallel printer interface LPT2 (IRQ5) and the I/O-address 270h is set.
Should your PC have two parallel printer interfaces or should the above settings already be used (e.g. sound
card etc.) the hardware settings of speed card must be changed as follows:
Caution :
The hardware settings must comply with the software installation (see chapter 6.1.1).
Setting the hardware interrupt
The hardware interrupt can be set with the jumper located on the below edge of the card.
Note :
Interrupt on default: IRQ5 → (LPT2)