Security Tronix ST-DVR7204G, Руководство пользователя

Страница: 21 / 89

v2.0 11/8/11 21
Select the desired day from the drop-down menu or ALL for the entire week. Four
possible time slots are available for each day. Use the mouse and soft keyboard to
enter the required time periods. Upon doing so the graphic will adjust to indicate the
selected days and time periods. When done, click
OK .
g. INTERVAL – Set an interval period in seconds. If there are several motion detection
signals occurring within the interval period only one alarm signal is turned on.
h. ALARM OUTPUT – There is no alarm function with this model DVR
i. DELAY – Period during which the alarm sounds after the alarm input returns to
standby status. Set a delay in the range of 10 to 300 seconds.
j. RECORDING CHANNEL – Select one or multiple recording channels for the video
signal when the alarm is activated.
k. TOUR – Upon a motion detection or other alarm event the monitor will display a single
window beginning with the channel on which the alarm took place. If desired,
additional single windows per channel will sequence. The sequence interval is set by
going to
Main Menu , clicking on the System icon, clicking on the Tour icon and
entering the interval period in seconds.
l. PTZ ACTIVATION – In the event of a motion detection or other alarm a PTZ camera
can be activated and set to automatically pan and or cruise among pre-determined
spots. By clicking on
SET a PTZ Activation screen similar to the one below appears.
For each PTZ camera select the type of PTZ function desired from the drop-down
menu. When done, click
OK . Note for PTZ activation to work, the PTZ camera has to
be configured by going to Main Menu , clicking the System icon, and clicking the PTZ
Config icon and entering the settings. Once done, the PTZ’s presets, pattern or cruise
settings must be created. This is done by calling up the PTZ Control through the
Short-cut Menu .
m. DELAY – Once the alarm stops the recording will continue for a set period of 10 to
300 seconds then stop.
n. SHOW MESSAGE – If the checkbox is highlighted an Alarm Status screen will appear
on the monitor when a motion detection event occurs.
o. BUZZER – If the checkbox is highlighted a beep will be heard when a motion
detection event occurs.
p. SEND EMAIL – If the checkbox is highlighted an email will be automatically sent to a
designated individual when a motion detection event occurs. Go to Main Menu , click
the System icon and then click the NetService icon to enter the desired email setting.
q. After all selections are made click OK .