25
ENFORCER Access Control Keypad with Proximity Card Reader
SECO-LARM U.S.A., Inc.
Programming the User Code Entry Mode (continued):
NOTE
: If the keypad was previously programmed for manual code entry mode and then is
reprogrammed for auto entry mode, any codes whose length exceeds the number of
digits of the master code will no longer operate the keypad. However, if the keypad is
reprogrammed for manual entry mode, the longer codes will again operate the keypad.
Programming the Keypad Sounds:
Some of the keypad sounds can be programmed off:
•
Keypad audible mode – All the keypad’s status beeps are enabled.
•
Keypad silent mode – The successful key entry beep (1 beep) and the unsuccessful user code
or card entry beeps (5 beeps) are disabled. However, the warning and power-up delay beeps
remain active. This provides for a quieter work environment.
To Program:
•
To enable keypad audible mode (default):
71 1 #
•
To enable keypad silent mode:
71 0 #
NOTE
: This programming function only impacts the keypad sounds. It does not impact the output
relay activation sounds (see “Programming the Output Relay Activation Sounds” below).
Programming the Output Relay Activation Sounds:
The keypad output sounds can be programmed for one of three modes:
•
No beeps
– The keypad will not beep when an output is activated:
72 0 #
•
1-second beep (default) – The keypad will beep for 1 second when an output is activated:
72 1 #
•
2 short beeps – The keypad will beep twice when an output is activated:
72 2 #
NOTE
: This programming function only impacts the output relay activation sounds. It does not
impact the keypad sounds (see “Programming the Keypad Sounds” above).
