Seastar Solutions Autopilot Pump, Руководство по эксплуатации

Страница: 12 / 32

8
SEASTAR Hydraulics
Install Helm Pump(s)
• Install SeaStar Helm pump(s) using the instructions provided
with your helm(s).
Install Steering Cylinder(s)
• Install SeaStar steering cylinder(s) using the instructions
provided with your cylinder(s).
Autopilot Pump Mounting
• Using the four (4) holes in the mounting bracket, mount the pump
using #10 fasteners in your desired location. Prior to drilling,
confirm that there is sufficient room to allow for hose connections
and tightening of these hoses.
• Mount the autopilot pump as close to the cylinder as possible, in
a cool and dry location, away from excessive heat sources such
as engine manifolds. Avoid any areas that seem to collect water.
• Install the Autopilot pump in a vertical position (refer to figure 3).
DO NOT mount the unit in a horizontal position.
Step 1 Mounting and Plumbing
10
ϒ
10
ϒ
AUTOPILOT
MUST MOUNT
VERTICALLY
Figure 3.
To assist the installation, a
mounting template is provided
on page 25.
NOTICE
The SeaStar Autopilot pump will
make a noise similar to common
Autopilot pumps; this should be
taken into consideration when
locating a mounting area for
the units.
NOTICE
Autopilot pump must be mounted
at a lower height than the highest
helm pump in your system.
NOTICE
The SeaStar Autopilot pump may be hot to the touch. DO NOT
mount the pump in an area where fabrics and/or any other
flammable materials may come in contact with the units.
WARNING
1.1
1.2
1.3
AUTOPILOT PUMP