Seagull Models Husky, Инструкция по сборке

Страница: 31 / 32

31
www.seagullmodels.com
CONTROL THROWS.
Ailerons: 12mm - 15mm up
12mm - 15mm down.
Elevator: 12mm - 15mm up.
12mm - 15mm down.
Rudder: 20mm - 30mm left.
20mm - 30mm right.
80mm.
*If possible, first attempt to balance the model
by changing the position of the receiver battery
and receiver. If you are unable to obtain good
balance by doing so, then it will be necessary
to add weight to the nose or tail to achieve the
proper balance point.
With the wing attached to the fuselage, all
parts of the model installed ( ready to fly), and
empty fuel tanks, hold the model at the marked
balance point with the stabilizer level.
Lift the model. If the tail drops when you lift,
the model is “tail heavy” and you must add
weight* to the nose. If the nose drops, it is
“nose heavy” and you must add weight* to the
tail to balance.
Accurately mark the balance point on the
botttom of the wing on both sides of the
fuselage. The balance point is located
60 mm
back from the leading edge of the wing at the
wing root. This is the balance point at which
your model should balance for your first flights.
Later, you may wish to experiment by shifting
the balance up to 10mm forward or back to
change the flying characteristics. Moving the
balance forward may improve the
smoothness and arrow- like tracking, but it
may then require more speed for take off and
make it more difficult to slow down for landing.
Moving the balance aft makes the model more
agile with a lighter and snappier ”feel”. In any
case,please start at the location we
recommend .
1 4) Do not turn plane upside down. Only low
wing models should be turned upsidedown for
balancing. Remove this paragraph, it is not
intended for use in the instructions. it is a note
for you.High Wing models must be balanced
upright.
3) With the model upright, place your
fingers on the masking tape and carefully lift
the plane.