E-12
Mounting the Camera in the Housing
1
Turn the lock knob
2
Open the rear case
3
Remove a camera from a front case
Removing the camera from the housing
Make sure that there is no dust
or scratches on the O-ring /
O-ring contact surface before
closing the rear case. Then
close the rear case and close
the lock knob
Fig.3
Fig.4
3
A substantial difference between the
external (water) and the internal
(camera and air) temperatures
sometimes result in dewfall on the
inside surface of the housing lens.
This phenomenon typically happens
when the camera becomes hot due
to long and consecutive use. Use
the optional Silicagel (62108) as
shown in Figure 4 to reduce dew
condensation.
After the camera is mounted in the
housing, make sure to check that all
of the housing's control parts work
properly and the camera functions
correctly.
CAUTION
Desiccant pack
(Silicagel)
See:
“Opening and Closing the Housing”
(P. E-9)
E-11
Part A
Anti-reflective tape
Mounting the Camera in the Housing
To avoid flooding by trapping,
remove the strap / protective cover /
metal strap clips from camera
before installation.
CAUTION
Place the anti-reflective tape on
the lens nameplate (part A) on
the camera
1
Fig.1
Fig.2
Turn off the power of the camera
and place it as shown in Fig.2
2
