E-20
Specifications
Compatible
camera
Sony DSC-RX100/DSC-RX100M2
Controls
Construction
Body: Corrosion-resistant aluminum alloy
Depth rating
100m (330ft)
Dimensions
Approx. 147
(
W
)
×97
(
H
)
×117
(
D
)
mm
Weight
Approx. 900g(housing only)
Accessories
Control dial, Shutter lever, Zoom lever, Power
button, Mode dial, Movie-record button, MENU
button, Selection button, Control wheel, Delete
button, Playback button, Fn button
* The specifications and appearance are subject to change without notice.
・
Silicone grease
・
O-ring remover
・
Anti-reflective tape
・
Mode dial rubber large (for RX100)
・
Wheel rubber large (for RX100)
・
Rear cushion rubber large x4 (for RX100)
・
Rear cushion rubber small x4 (for RX100M2)
・
O-ring maintenance manual
・
Instruction manual (this manual)
Attached accessories to the product :
・
Port cap
・
Fiber-optic cable socket cap (x2)
・
Hand strap
・
Zinc anodes (x2)
E-19
CAUTION
Maintenance and Storage
After rinsing, dry the product well with a soft dry cloth, then let the product dry
in the shade, out of direct sunlight.
Do not dry the product by heating (using a hair dryer, for example). Heating can
deform and damage the product.
If you will not use the product for an extended period of time, store it away from
high temperatures, high humidity, direct sunlight, or extreme cold.
Do not store the product with naphthalene or camphor mothballs, or in locations
such as a laboratory where chemicals are used. This environment can cause
mold, rust, corrosion or malfunction.
Always remove the camera from the housing after use. Thoroughly wipe off water
before opening the housing and avoid any water drops inside the housing.
After using the product, maintain the O-rings before storing. Examine the O-rings
before and after each dive. We recommend early exchange of the O-rings, at
least once a year.
Every two years we recommend a complete overhaul of O-rings regardless of
the frequency in use, for the best performance of the product.
After each use in salt water, make
sure it’s watertight, then soak it
sufficiently in fresh water.
Insufficient soaking causes damage
by salt to the product. Salty residue
may be left on the product where it will
crystallize as it evaporates. Crystallized
salt is hard to dissolve and difficult to be
removed once formed, and it will result in
water leakage.
Never use chemicals, cosmetics, any petroleum solvents such as paint thinner,
or neutral detergent on the product. They may deform and damage the product.
