29
To the attention of users and technicians
FULL TANK MANUAL RELEASE SYSTEM
WARNING:
Always switch off the main power (110V or 230V) before servicing the operator.
SEA recommend to the end user to release the operator only in case of power failure.
Always contact the professional installer in case of not correct working of the operators.
To release operate as follows:
open the lock cover, insert the key, turn it about 90° clockwise (see Fig. 58) and open the lid.
Take the red key located under the lid, insert it and turn it about 90° anti-clockwise (see Fig. 59).
To relock the operator do as follows:
turn the red key clockwise until it stops (see Fig. 59), remove it, put it under the lid
and close the lid again.
Attention: Turning the key over 1 turn (360°) could damage the release.
Turn the key anti-clockwise to tighten the lid, remove the key and close the lock cover.
Fig. 58
Fig. 59
Open
Close
Release
Lock
To release operate as follows:
open the lid, insert the key, rotate starting from the
stop of departure from ½ turn to a maximum of 1 turn
(360°) in anti-clockwise direction (see Fig. 56)
To relock the operator do as follows:
turn the key into clockwise direction to the
maximum, afterwards bring back the key into the
position 0, turn it again in anti-clockwise direction
(see Fig. 57), remove the key and close the little door
again.
Attention: Turning the key over 1 turn (360°)
could damage the release.
Fig. 57
Fig. 56
0
RELEASE SYSTEM VERSION 1
RELEASE SYSTEM VERSION 2
