Battery current (mA)
Battery (Ah)
800
360
200
12 or 16
7
2
Flashings Number
2
3
Flashings Number
6
7
8
9
10
Kind of alarm
Collision on obstacle
Reached maximum cycles
Alarm BUS
Motor failure
Alarm battery unloaded
4
5
+
S
-
GND
GND
GND PSOL BAT 28V
+
S
-
USER24
+
-
= charge 200mA
Solar Panel
Batteries
GND
+
12V
12V
Grey connector
CN1
= charge 360mA
= charge 800mA
~
~
~
+
-
Cod.23101110
Battery signals:
- Batteries loaded up to 20V:
green led turned on, red led turned off.
-Batteries with tension between 20 and
18V:
green led flashes, red led is off ; in
absence of net the flashing lamp signals
that the battery is unloaded sending
flashes with less frequency.
- Unloaded batteries <18V:
green led off, red led turned on fix. In
absence of net the cycle will be stopped
and the flashing lamp will send 10
flashes.
8
a ry c rg r
2 V B tte
ha e
sit v b tte y
Po i e a r
g iv
a
ch
r
Ne at e b ttery arge
The flashing sequence is signalled at every opening and closing of the automation on the warning lamp. The warning lamp will
send a flashing every second in opening and two flashings in closing, while it will remain turned on fixed in pause.
Kind of alarm
Photocell
Photocell in opening
Safety edge
Stop
Insert two 12V batteries connected in series.
CONNECTION OF BATTERIES
TO BATTERY
CHARGER CARD
ALARMS INDICATIONS
ALARM SIGNALS
The dammages with 2,3, 4 and 5 flashings, refer to normally closed contacts, therefore verify if such are the connections and/or
the correct working of the photocells, of the Stop button and/or of the safety edge.
2. The failure with 6 flashes refers to a collision with an obstacle which has been revealed by the ammeter sensor, therefore it is
necessary either to repalce the motor or to verify the conditions of the connections.
3. Periodically, in relation to the number of manoeuvre and the type of gate, it is recommended to execute, if the gate has
modified the attritions and it doesn't work,
the re-programming of the times of learning on the electronic board.
The dammage with 7 flashes refers to the attainment of the established maximum cycles for the maintenance of the control unit,
therefore it is necessary to perform the maintenance and to put on zero the number of cycles, according to the following
procedure: Through the button SEL select the led 22 of the motors’ speed, keep pressed the chosen button for more than 5
seconds.
4. The dammage with 8 flashes indicates a generic error on the BUS, this means that there is a short circuit on one of the
connected devices to the BUS, and it it necessary to verify the connections and the functionality of the connected devices or the
connected devices are not correctly joined between them (see paragraph on the BUS management)
5. The failure with 9 flashes refers to a shortcut on the motor, therefore it is necessary either to replace the motor or to verify the
conditions of the connections.
(BAT)
67410925
18
USER 2 - 24V
International registered trademark n. 2.777.971
M
3
REV 02 - 06/2010
