!!
EXTERNAL RECEIVER
Example: Connection of a
radio receiver
For the connection of the
receiver refer to the relative
instructions manual.
RADIO TRANSMITTER SELF LEARNING
WITH RECEIVER ON BOARD OF CONTROL UNIT
Notes:
- Enter radio transmitters learning only when the working cycle stops and the gate is closed.
- It’s possible to memorize up to 800 codes (buttons).
- If all available codes have alredy been memorized and you try to memorize a further code, the led 21 (red) will flash for signalling the error.
- If the board receives a code which was already associated to another function it will be updated with the new function.
WARNING: Make the radio transmitters programming before you connect the antenna and insert the receiver into the
special CMR connector (if available) with turned off control unit. (The control unit automatically recognizes if the receiver is a RF
or RF Roll module). Note: With a RF module it will be possible to use only 12 bit radio transmitters, that are Coccinella Dip and
Copy and Smart Dual. With RF Roll module it will be possible to use only Coccinella Roll radio transmitters.
1. Press repeatedly the button “MENU” till to select the led 15 (red), at this point press the button “SET” and the led15 will flash together with
the led 19 (green) to signal that it waits for a code to be associated to the total opening;
2. Press the desired button of the radio transmitter, the led19 (green) will turn off to signal the memorisation of the data; now it returns to flash
for 5 seconds waiting for other codes.
3. If it is desired to also associate a command to the pedestrian start, press
SET
again, the led 20 (yellow) will flash for signalling that it is waiting
for a code to be associated to the
pedestrian opening;
4. Press the desired button of the radio transmitter, LED 20 will turn off to signal the memorisation of the data; now it will turn to flash waiting for
other codes to be associated to the pedestrian start. If no other buttons are pressed within 5 seconds the programming will be left.
5. At this point it is possible to press the desired button of the radio transmitter and the leds 19,20, 21 (green, yellow, red) will show the
available memory, led19 (green) shows the occupied memory, less than 50%, led 20 (yellow) shows the occupied memory , more than 50%,
led 21 (red) full memory.
6. To delet all memorized codes keep pressed for more than 5 seconds the adjusted button until the leds yellow, red and green will
flash contemporarily to confirm the cancellation.
JOLLY functions
: It is possible to monitor the state of occupation of the of the radio transmitter memory.
1 2
1 2
2
1
1 2
1 2
2
1
rt
St
a
S
a
t
e
d
t
r
p
C
o
m
o
m
C
C
m
o
+
-
M5
M7
M10
2
4V
Note
: The control unit, can be directly interfaced with the OPEN system for the management of Coccinella Rolling Code radio transmitters
67410925
14
USER 2 - 24V
International registered trademark n. 2.777.971
M
10
M
7
5
M
LED19
LED20
LED21
SET
MENU
LED15
GREEN
YELLOW
RED
Programming
REV 02 - 06/2010
