Sea Tel 9711 C, Инструкция по установке и эксплуатации

Страница: 72 / 160

9711 C & Ku-Band TXRX Configuring The Satellite Modem Interface.
10-1
10. Configuring The Satellite Modem Interface.
The configuration setup of an integrated satellite modem to the MXP is accomplished via the Communication Interface Page
(Configuration>Interfaces link on the navigational panel on the left hand side of the screen). In order to access this page, the
user must be logged in as either “Dealer” or “SysAdmin”. The current software load, IMA Ver 105 at the time of this release)
contains 6 commonly used satellite Modems (iDirect, Comtech, Gilat, Hughes, STM, and Viasat) as selectable presets and is
typically a prompted selection when using the new Commissioning Wizard. However, the MXP allows configuration of a
“Custom” modem type. The primary focus of this procedure is to define all of the parameter options made available to allow
the commissioning technician to properly integrate any compatible L-Band Satellite modem.
10.1. Satellite Modem Interface
1. If not already, log into the system using
the “Dealer” or “SysAdmin” credentials.
2. On the left hand side of the screen, under
Configuration, select the “Interfaces”
link.
3. On the right side of the screen,
approximately half way down is the
“Modem Lock Mute” section. This section
is where the user, via drop down menu
selection and/or mutually exclusive radio
buttons, defines:
•
Reflector
•
Modem Type
•
Modem I/O
•
Lock Input
•
Block Output