Sea Tel 9711 C, Инструкция по установке и эксплуатации

Страница: 31 / 160

Installation 9711 C & Ku-Band TXRX
3-10
3. The person inside now loosely
installs the rest of the
hardware in all of the flanges.
Do NOT tighten the bolts at
this time.
NOTE: The person who is working
inside installing hardware, applying
Loctite, tightening hardware and
cleaning the inner flanges will remain
inside until the cap and lifting brackets
are installed.
4. Assure good horizontal
alignment of the panels.
Good alignment of the
bottom edge of the panels is
important for good seal
between the lower and upper
panels.
5. To provide a clean caulked
seam all around the panels:
apply painters masking tape
to the outside perimeter of
each of the panels about ¼“
from the top, bottom, left and
right edges at each flange
joint. The tape will be
removed just before the
radome caulking has had time
to set.
6. Open each seam wide enough
to install a good bead of
silicone caulk, apply Loctite
and firmly tighten all of the
bolts in that seam (Smaller
dual beads of caulking can be
applied from outside and
inside if you prefer).
7. Clean excess caulking off of
the flange areas inside and
outside the radome.