Sea Tel 9711 C, Инструкция по установке и эксплуатации

Страница: 154 / 160

Procedure, General Strain Relief Installation
Page 2 of 4
Document No
136505 Rev A
Form # 117140-D
5.4 Sealing the hole edges
CAUTION : Cut edges can allow water and/or ice ingress and weaken the fiberglass laminate
or structural foam. It is essential to seal all cut edges thoroughly with fiberglass resin to
preserve the base pans structural strength.
CAUTION: Fiberglass paste or RTV silicone sealant will not wick into and seal the fiberglass
strands as well as fiberglass resin, ONLY use fiberglass resin (such as TAP PLASTICS MARINE
VINYL ESTER, or equivalent) for sealing the cut edges.
Follow the manufacturer’s instructions to mix a small amount of fiberglass resin and catalyst,
then working quickly, use a disposable brush to apply mixed fiberglass resin to the hole edges,
both inside and out.
Allow the fiberglass resin to set per resin manufacturer’s instructions.
Note: Like all chemical reactions, set time will be temperature/humidity dependent.
5.5 Refer to strain relief assembly draw ing 124903 (attached)
Being careful not to damage either the radome or the strain relief threads, use adjustable
pliers to install strain reliefs into the base pan with the locking nuts & sealing rings.
5.6 Installing Cables
Pass the end of the cable through the strain relief cap, washer, rubber stopper and then
trough the body of the strain relief into the radome interior.
Pull sufficient excess cable into the radome to route the cable to its intended termination
point. Once cables have been installed, slide the strain relief cap, washer and rubber stopper
up into the body of the strain relief.
Tighten the cap until the rubber compresses sufficiently to prevent the cable from sliding in
the body of the strain relief.
6.0
Records. N/A.
7.0
Training. N/A
8.0
References.
Strain relief assembly drawing (P/N: 124903)