
84
Apply dielectric grease on bulb contact
surface.
When installing the bulb under the up-
per terminal plate, it is possible that
the bulb remains loose. The cover will
compress the terminal plate against
the bulb at reinstallation.
Stern Light
Unscrew lens counterclockwise and
pull it out.
TYPICAL
1. Unscrew then pull
Pull bulb to remove it.
TYPICAL
1. Pull bulb out
Apply dielectric grease on new bulb
contact surface.
Assembly is the reverse of removal
procedure.
Sacrificial Anode System
Corrosion of metal parts, especially
those exposed to saltwater, is com-
mon for boats. Corrosion can be
caused by stray electric currents from
shore power installations, improperly
grounded A.C. lines and circuits, and
poorly insulated D.C. powered equip-
ment from boats moored nearby. Cor-
rosion is accelerated when electric
current is present.
Sacrificial anodes are attached to cer-
tain parts of this boat to reduce corro-
sion. The anode corrodes, rather than
the part to which the anode is at-
tached.
Replace each anode when 50% by
weight has corroded away.
Anodes are attached at the following
locations:
– Ride shoe/Cooling plate
– Pump housing
– Reverse gate support
– Steering nozzle
– Reverse gate
TYPICAL
1. Anode installation shown
NOTE:
Inspect anodes each time boat
is to be launched. Do
NOT
paint an-
odes or apply protective coatings.
F23H07Y
1
F23H08Y
1
1
F23L15Y
lmo2005-007a_1.book Page 84 Wednesday, September 1, 2004 3:27 PM
Содержание Challenger*180
