4
6.0 Fixing the mounting plate
The top of the mounting plate is identified by a screw fixing lug.
Ensure the area to mount the panel is flat. Hold the mounting plate up against the surface to which it is to be
fixed, with the cable coming though the central hole. Check the panel is vertical using a spirit level before marking
through the holes and remove the plate.
Drill appropriate sized pilot/fixing holes and use plastic plugs/cavity fixings where appropriate to fix the mounting
plate.
7.0 Binding addresses (OS2)
8.0 Binding addresses (OSloop
)
The binding addresses of the panel are pre-configured at the factory
and for each indicator it is printed in the bottom left corner. For OS2
bindings, this is a single digit number.
The OSLink addresses set on the OSLink card rotary address
switch must be set to match each LED zone.
After changing OS2 OSlink address, the network must be restarted
using the install button on the OSLink card.
The binding address for each indicator it is printed in the bottom
left corner. For OSLoop bindings, this is a dotted address.
The binding contains the address of the coordinator and a sub-
address of the OSLoop MCP. For example 1.0 refers to OSLoop
coordinator at address 1 with MCP at zone switch set to 0.
If not already set, each OSLoop coordinator needs to have the
OSLink address set using a POP configuration tool (Parameters-
>OSLink-> OADD). After changing this parameter, it is necessary
to reset the coordinator.
Ensure the MCP zone switches are correctly set to match the sub-address.
