9
In normal standby condition, the green LED will be on solid and the red and yellow indicators off.
The status indicators in the lower section of the panel use a single yellow LED to indicate global failures,
rain sensor active and maintenance states. Maintenance and rain sensor LEDs illuminate when active –
this does not indicate a fault.
The ‘service due’ indication can only be reset by service personnel.
If enabled, an audible alarm will sound with a rising tone (smoke vent active), intermittent beep (fault) or
continuous tone (SHEVTEC® Repeater Panel fault). Press the silence button to cancel the panel audible
alarm. The alarm override will remain until the cause of the alarm is cleared. On OSLoop systems, the
silence button will also globally silence the local sounders at the coordinators and MCPs.
The lamp test button may be used as part of a regular inspection regime. Ensure that all LEDs can be
turned off and on and that (if enabled) the sounder beeps.
16.0 Disposal
At end of life, this product should be disposed of in compliance with the WEEE waste electronics directive. For
advice on disposal consult the local environmental officer or contact SE Controls.
Notes
SE Controls
Lancaster House
Wellington Crescent
Fradley Park
Lichfield
Staffs
WS13 8RZ
Tel: 01543 443060
Fax: 01543 443070
SE Controls is a Registered Trademark
