Operation & Maintenance Manual
──
LG918 Wheel Loader
74
blasted rock.
Notice:
Do not let the blasted rock go under the bucket which will make the front tires leave from the ground
and slip. Try to hold the load in the center of the bucket; otherwise, if the load is on one side of the
bucket, it will be unbalanced.
z
Raise the lift arm to prevent the bucket from inserting too
deeply while thrusting the bucket into the material. The
tires will bring ample traction by raising the lift arm.
If enough material is loaded into the bucket, operate the
working equipment control lever to take back the bucket in
order to load it fully.
Remark:
If the shovel edge moves up and down when thrusting
material into the bucket or when digging, the front tires will
leave the ground and slip.
z
If there is too much material loaded into the bucket, the
bucket must be dumped and titled quickly to remove the
excessive load so as to prevent the material from
dispersing during transportation.
Digging and Shoveling Material on Flat Ground
Lightly set the bucket edge leaning on the ground (see
picture) when digging and shoveling material on flat
ground. Be careful not to fasten the load to one side which
will cause unbalance. This operation should be carried out
carefully in gear
.
Ⅰ
z
Lightly set the bucket edge facing down.
z
When driving the machine forward, operate the working
equipment control lever to let the lift arm lower down to
the proper position so that it can pick up a thin layer of
