SCS Sentinel SCS1 COMFORT+, Руководство пользователя, Страница: 44 / 48

EN
::: 44
Query the customized SMS
message content
Query zone 00-99 the content of SMS message customized.
example: Send 12348101# to the alarm panel to query for zone 01 message
content.
81
+
【
00-99
】
+
【
#
】
note: “1234” string shown above table all represents the password. user can change password and thus should
adjust the commands listed accordingly.
remark:
this machine can be used as a mobile for conversation. to do that, on the keyboard, put in #0013812345678# where
13812345678 is the phone number you’re going to connect. at the end of your call, press diSarM key, press *, then
press # to exit.
this system is a dual-tech system that can use both pStn landline and gSM mobile network for outgoing alert. the
pStn landline is the preferred mode of calling, gSM network will then be used until all six groups of phone number
cannot be connected using pStn landline.
5.1 After receiving the Panel Alert:
after panel alerts, it will automatically dial the preset telephone number for three times until connected. When
the user picks up the phone, a piece of pre-recorded voice message will be played back immediately and let
the receiver noted about the event. upon receiving the call, it can also control the alarm panel remotely via the
phone (according to the command below). user will not be asked for password upon connected and alarm will
automatically hang up call within receiving any instruction within 20 seconds.
[1] key: arming [2] key: disarming
[3] key: monitoring open [4] key: monitoring closed
[5] key: turn on announcement [6] key: turn off announcement
[7] key: siren ringing [8] key: stop siren sound
[9] key: turn on relay [0] key: turn off relay
[*] key: hang up, system will not dial the next number on list.
remark:
if not hang up using [*] key or disarm using [2] key,
the system will retry to call the next phone numbers on list until one connected.
panel will not ask for password when dialing out upon alarming.
5.2 Remote dialing In operation:
Remote-control operations can be done via any phone. You can just dial into the alarm panel and user will be asked
for password upon connected and alarm will automatically hang up call within receiving any instruction within 20
seconds or password is incorrect. (original password 1234)
[1] key: arming [2] key: disarming
[3] key: monitoring open [4] key: monitoring closed
[5] key: turn on announcement [6] key: turn off announcement
[7] key: siren ringing [8] key: stop siren sound
[9] key: turn on relay [0] key: turn off relay
[*] key: hang up,
[#] key: Enter the system remote configuration mode, without receiving no instruction,
the panel will automatically hang up after 20 seconds.