WATER RESERVOIR
1. Shut off the water supply to the ice maker.
2. Remove front panel and reservoir cover.
3. Disconnect water inlet tube from reservoir inlet
fitting.
4. To remove float valve, push in "locking tabs" as
shown and pull float up.
Note: The plunger/seat is available separately as a
part.
5. To remove reservoir, pull up and remove water
sensor.
8. Disconnect water outlet tubes.
9. Remove mounting screws from reservoir
bracket and remove the reservoir from the ice
maker.
10. Reverse to reassemble.
BIN CONTROLS (Ice Level Sensors)
1. Disconnect electrical power.
2. Remove front panel.
3. Remove control box cover.
4. Locate ice chute, at the base of the chute, in
front of and behind it are two plastic bin control
mounts.
5. Slide each bin control to the left, and in the
control box, disconnect the electrical leads
connecting the bin control to the circuit board.
6. Reverse to reassemble, be certain that the bin
controls are aligned so that the ice level sensors
are visible (centered) through the holes in the ice
chute.
LOCKING
TABS
FLOAT
ASSEMBLY
Plunger/Seat
ICE
CHUTE
SLIDE BIN
CONTROLS IN
AND OUT
REMOVAL AND REPLACEMENT: Water Reservoir & Bin Controls
NME1850R & FME2400R
January 1995
Page 27
