Scientifica SliceMate, Руководство пользователя, Страница: 11 / 18

11
3. To replace the heat exchanger tubing, the spring clip must first be raised.
4. The Stainless Steel lid of the heat exchanger is removed by loosening the 4
hex button head screws and washers using a 2mm Hex wrench.
5. Once the heat exchanger lid has been removed the old tubing can be
pulled free.
6. Now install the new tubing; take the angled cut end, have this extending
from the edge of the spiral by 6.5 to 7.5mm (to allow attaching the silicon
valve tubing later on). Being careful not to kink or flatten the tube; gently
press the polythene tubing into the spiral groove following the whole track
until the tubing extends out of the other side. This emerging end can now be
trimmed to protrude by 6.5 to 7.5mm from the edge of the heat exchanger
at an angle of approximately 45º.