Scientifica SliceMate, Руководство пользователя, Страница: 10 / 18

10
Now trim the mesh using a scalpel.
Disassembling the SliceMate
The 19” rack controllers must be switched off prior to removing the assembly
Once switched; off the 16 way circular connector can be disconnected along
with the fluid connections. The SliceMate can now be removed from the SliceMate
base. Unscrew the two black Acetyl knobs in an anticlockwise direction and lift the
SliceMate clear from the table.
Replacing the heat exchanger tubing
1. Firstly obtain a piece of replacement tubing. This should be polythene tubing
with an O.D of 1.22mm and an ID of 0.76mm cut with 45º angle (to allow
easy mating with the silicon tubing) at one end to a length of 460mm.
2. Disconnect the silicon tubing from either side of the heat exchanger as
below.